There are screws holding the radio unit in place but they are under the trim piece, that needs to be released first. Please see the attached video showing this at about the 8 minute mark. view full answer...
Acccording to MaxxAir, you'll want to remove power from the MaxxAir # MA00-04000K fan for a minute or two, then reconnect to reboot the circuit board. In the vast majority of instances, this will fix the problem. You should also check that the fan is receiving 12 volt power and that the rain sensor isn't wet. view full answer...
No you aren't missing anything; if the 34" to 60" Valterra RV Sewer Hose Carrier # A04-3460 doesn't have the proper length for your RV, then you will need to go with the longer option. There isn't an 8 foot carrier, but there is one that is close, the adjustable 50" to 94" Valterra RV Sewer Hose Carrier # A04-5094.
I have added links below to a pair of video reviews for you to check out as well if you'd like to take a look. view full answer...
With the battery of of your trailer disconnected for the off-season the Lippert Ground Control 3.0 # LC675817 will loose the zero point calibration so you will need to reconfigure it before taking the trailer on the first trip of the new season.
This is also the case if your battery goes dead or gets low the zero point calibration could be lost and need to be reconfigured.
I would just add reconfiguring the system to your beginning of season checklist so that you do not forget.
I included... view full answer...
I was not able to find any install photos of the No-Drill Mount Kit for Firestone Air Command part # F2612 which is for the Air Command Compressor System part # F2610 but I can tell how it's supposed to be installed from our photos. The two brackets will sandwich the frame via the carriage bolts. One bracket will go on the inside of the frame and the other on the outside. The l-shaped bracket will house the compressor and manifold. I have attached a photo to better assist. view full answer...
Go To Results